Manual installation of the speed of 5 and 6 of the Mazda 3 short Shifter 2010

Read this excerpt from the content of that taken from the speed manually moving a brief 5 and 6 of the 2010 mazda 3: installation Start the installation by parking on a flat surface, as you will need to engage and disengage the hand brake and shift gears into neutral. If you are unable to do so and are required to install short shifter on slightly inclined surfaces, place wooden blocks with the front or rear wheels to prevent moving during work car The Code Fragment, which guide step-by-step installation:

Work in the Bay of engine, start deleting field primary air by removing the lightning bolt on the upper part of the air as pictured to the left. Use the slot 10 mm and zapadkami. Reserve for reinstall later.Unclip clips of two (2) holding the upper part of the air as pictured to the left.Disconnect the connectors MAF as pictured to the left.Unclip the rubber hose on consumption as picturedLoosen under the bolts holding the throttle body inlet pipes for using the connectors 10 mm and more ... and ratchet.

Download the 2010 Mazda 3 Short Shifter 5 and 6 speed manual installation: 2010 Mazda 3 short Shifter 5 and 6 speed Manual installation (822 KB, 10 pages)